ORO LOMA SANITARY DISTRICT
STANDARD OPERATING PROCEDURE
2007 INTERNATIONAL HYDRO-JETTER
Written by
Reviewed by Bert Gileno,
2007 INTERNATIONAL
HYDRO-JETTER
OPERATORS S.O.P.
TO BE PERFORMED WHILE IN
CAB:
1. Bring vehicle to a complete stop.
2. Place transmission selector in neutral.
3. Engage parking brake.
4. Ensure 4-way flashers, beacons, and light bar are on as needed.
5. Engage P.T.O. switch. (red indicator light signifies the switch is in the on position) (see cab interior item #1)
6. Check for traffic before exiting vehicle using three point dismount.
TO WATCH VIDEO CLICK PHOTO ABOVE
TO BE CONTINUED AT REAR OF
TRUCK:
1. Set up traffic control as needed.
2. After removing lid, pull down on the reel control handle to lower the desired
cleaning tool into the manhole. (see operators control station item #2)
3. Place the cleaning tool in the line segment to be cleaned.
TO
WATCH VIDEO CLICK PHOTO ABOVE
4. Move the water control selector valve handle to the hose position. (see operators control station item #3)
5. Pull out the pump engagement handle, turn clock wise to lock. (see operators control station item #4)
6. Rotate the reel speed control knob counter clockwise to desired setting. (see operators control station item #5)
7. Move the throttle on/off switch to the throttle on position. (see operators control station item #6)
8. Hold the throttle fast/slow switch in the up position, while simultaneously pulling down on the reel control handle, until desired pressure and/or reel speed are achieved (see operators control station item #7)
9. When desired footage is achieved, release the reel control handle and turn the throttle on/off switch to off position.
TO WATCH VIDEO CLICK PHOTO ABOVE
10. Place the hose in the hose reel guide, and secure.
11. Rotate the reel speed control knob clockwise to the closed position.
12. Switch the throttle on/off switch back to the on position.
13. Hold the throttle fast/slow switch in the up position until desired pressure is achieved.
14. Push up on the reel control handle, while rotating the reel speed control knob counter clockwise until desired retrieval speed is achieved.
15. When desired hose retrieval is achieved, release the reel control handle.
16. Switch the throttle on/off switch to the off position.
17. Rotate the pump engagement handle counter clockwise and depress in all the way.
18. Move the water control selector handle to the tank position.
19. Remove the cleaning tool from the pipe.
20. Push up on the reel control handle to remove the cleaning tool from the manhole.
21. Immediately replace the lid.
22. Secure the cleaning tool and close the rear door.
23. Remove traffic control devices.
TO WATCH VIDEO CLICK PHOTO
ABOVE
TO
COMPLETE PROCEDURE:
1. Using three point mount, re-enter cab.
2. Disengage the P.T.O. switch. (red indicator light should go out)
3. Depress the brake pedal, place the transmission selector in the drive position, release the parking brake, and when safe to do so,
proceed to the next set up.
4. Ensure that 4 way flashers, beacons, and light bar are on/off as needed.
TO WATCH VIDEO CLICK PHOTO ABOVE
Cab Interior Hydro #026
Item #1
P.T.O. Switch
Operators Control Station Hydro #026
